Turn signal/parking lamp bulb, replacing
CAUTION:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.
Removing
- Remove headlamp → Headlamps, removing and installing .
- Turn bulb holder - arrow - counter-clockwise and pull it from housing.
- Pull bulb out of bulb holder.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing bulb holder, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Install headlamp Installing .