Pistons, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications: 50 Nm + 90° turn.

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston using a commercially available piston ring compressor.

Installed position:

Piston. Refer to Figure.
Connecting rod. Refer to Figure.

-- Install the connecting rod bearing cap according to the marking.

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .