Front Axle Toe, Adjusting

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2- and make note of the value. The dimension -a- should be the same before and after adjusting on the left and right.

Fig 1: Measuring Tie Rod / Tie Rod Head Dimension

Courtesy of AUDI OF AMERICA, LLC

-- Loosen lock nut -B-.

Fig 2: Locating Lock Nut

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Counterhold the tie rod end -C- when loosening the lock nut -B-.

-- Adjust toe on left and right-hand wheels at hex -A-.

Be Sure That Boot Is Not Twisted after Turning the Tie Rods.

Twisted boots wear out quickly.

-- Tighten lock nut -B- and check toe-in value again. Refer to STEERING GEAR, SERVICING, HYDRAULIC POWER STEERING GEAR .

After tightening lock nut -B- it is possible that the value deviates slightly.

If the measured toe nevertheless lies within the tolerance, the adjustment is correct.