Overview - Tire Pressure Sensor
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Left Front Tire Pressure Monitoring Sensor -G222-, Right Front Tire Pressure Monitoring Sensor -G223-, Left Rear Tire Pressure Monitoring Sensor -G224- or Right Rear Tire Pressure Monitoring Sensor -G225-
- Replace the valve insert each time a tire is changed. Refer to the Parts information.
- When using used tire pressure sensors, replace the union nut, valve insert, seal, sealing washer and valve cap. Refer to the Parts information..
- After installing, visually check if the sensor is secure in its bed.
- Replace damaged sensors.
- Do not clean the sensors with steam blasting or strong compressed air.
- Removing and installing. Refer to TIRE PRESSURE SENSOR -G222- / -G223- / -G224- / -G225-, REMOVING AND INSTALLING .
- Valve Insert
- Replace damaged valves.
- When changing a tire, replace the valve insert.
- Sealing Washer
- When installing the new sealing washer, counter-hold it to prevent the valve body from pushing through. If the connection breaks, then replace the Tire Pressure Monitoring Sensor --.
- Seal
- When installing the new seal, counter-hold it to prevent the valve body from pushing through. If the connection breaks, then replace the Tire Pressure Monitoring Sensor --.
- Rim
- Tires, removing and mounting. Refer to TIRES, CHANGING, VEHICLES WITH TIRE PRESSURE MONITORING SYSTEM
- Union Nut
- 8 Nm
- Valve cap
- Use only original valve caps from the repair set. Refer to the Parts information.
- Do not use comfort valve caps or metal caps