Brake booster pressure sensor G294 , removing and installing

Removing 

• Remove plenum chamber cover.
• Pull electrical connector out downward.

Fig 1: Removing Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - arrows  -.

Fig 2: Disconnecting Brake System Vacuum Pump V192 From Non-Return Valve

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect brake system vacuum pump V192 from non-return valve as shown in illustration.
• - 1  - Brake booster
• - 2  - Vacuum line
• - 3  - Hose clamp

• - 4  - Pressure sensor
• - 5  - Check valve
• Remove pressure sensor.

Installing 

Installation is in reverse order of removal.