Left and right convertible top compartment cover locks, removing and installing
Removing
- Remove rear seat bench and backrest →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
CAUTION:
Observe safety precautions when handling pyrotechnic belt tensioners →
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS for BODY INTERIOR - CABRIOLET
- Remove respective rear belt retractor →
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS for BODY INTERIOR - CABRIOLET
- Disconnect electrical connector behind belt retractor.
- Bring convertible top into center position.
- Remove securing clips for front convertible top compartment well trim until compartment locks are accessible.
- Remove locking washer - 1 -.
- Remove push rod - 2 -.
- Mark exact position of bolts - 3 - and remove.
- Remove convertible top compartment cover lock and lay it sideways,
- Disconnect switch unit electrical connector and remove switch and lock.
NOTE:
- The connection is located behind the belt retractor.
Installing
Installation is reverse of removal, noting the following:
- Install bolts exactly at the markings made earlier. In this way, it is not necessary to adjust the locks.
- Ensure the convertible top compartment cover aligns with the side panel when closed.
- Check whether switch works with convertible top compartment cover closed.
Tightening torques → Convertible top compartment cover latch - assembly overview .