Rear 3-point seat belt with belt tensioner, assembly overview: Notes

1 - Belt

2 - Belt guide

3 - Connecting bar

4 - Idler roller

5 - Locating projection

6 - Anchorage point: Outer floor panel

7 - Bolt

• Tightening torque 55 Nm

8 - Bolt

• Tightening torque 55 Nm

9 - Belt reel/belt tensioner

• Removing 

• Disconnect battery.
• Remove rear bench seat → Rear seat bench, assembly overview .
• Remove rear seat backrest → Rear seat backrest, assembly overview .
• Open convertible top compartment.

• Remove bolt - 8  -.
• Disconnect belt tensioner connector Disconnect connector for rear seat belt tensioner .
• Remove belt reel - 9  -.
• Remove bolt - 7  -.

• Unclip front belt guide - 2  - and detach - 2  -.
• Open connecting bar - 3  - on belt guide - 2  -.
• Pull belt - 1  - out of belt guide - 2  - and Idler roller - 4  -.

• Installing 

• Plug in connector to belt tensioner Disconnect connector for rear seat belt tensioner .
• Screw belt reel - 9  - with bolt - 8  -.
• Feed belt - 1  - into idler roller - 4  -.
• Feed belt - 1  - into belt guide - 2  - with connecting bar - 3  - open.

• Close connecting bar - 3  -.
• Attach belt guide - 2  - at rear and press on belt guide - 2  - at front.
• Make sure belt guide - 2  - is engaged at front in side trim.
• Make sure outer floor panel anchorage point - 6  - is engaged in locating projection - 5  -.

• Screw outer floor panel anchorage point - 6  - with bolt - 7  -.
• Install rear seat belt in reverse order of removal.

10 - Latch plate