Positioning Vehicle On Hoist And Wheels
Raising with Air Suspension System Not Open
-- Switch on "Vehicle lift mode" before raising vehicle with hoist, refer to VEHICLE LIFT MODE .
This ensures no uncontrolled air suspension system regulation is activated.
-- Position hoist lifting arms under intended lift points on longitudinal members and raise vehicle.
Lowering with Air Suspension System Not Closed
-- Lower hoist and place vehicle on wheels.
-- Swing back hoist lifting arms.
-- Switch off "vehicle lift mode" and set desired driving mode, refer to VEHICLE LIFT MODE .
"Vehicle lift mode" is automatically deactivated when vehicle speed exceeds 10 km/h.
Lowering with Open Air Suspension System
-- Lower hoist and place vehicle on wheels.
If vehicle is not high enough to swing hoist lifting arms back (insufficient pressure in pressure reservoir), allow engine to run at idle. This switches the air supply unit compressor on.
-- The air suspension system can also be filled in "Guided Fault Finding", refer to SYSTEM, VENTING OR FILLING .
-- Switch off "vehicle lift mode" and set desired driving mode, refer to VEHICLE LIFT MODE .