Lines And Hoses Overview

1. Pressure line bracket to engine, refer to Fig 2.
2. Return hose to line bracket, refer to Fig 2.
3. Location of hoses on reservoir and reservoir bracket to body, refer to Fig 3.
4. Return hose clip to coolant hose, refer to Fig 4.
5. Return hose line bracket to body bracket, refer to Fig 4.
6. Return hose clips to refrigerant line, refer to Fig 5.
7. Hoses to hydraulic oil cooler, refer to Fig 6.
8. Return line bracket to subframe, refer to Fig 7.
9. Return line to coolant hoses, refer to Fig 7.

-- Use the bracket -3- to attach the pressure line -1- to the transport eye -2- or cylinder head. Tighten bolt -4- to 9 Nm (M6) or 22 Nm (M8).

-- Secure return hose -5- with line bracket -6- in bracket -8-. Secure the bracket -8- on the bracket -9- and tighten the bolt -7- to 9 Nm.

-- Position reservoir -4- on bracket -3- when installing.

-- Tighten the bracket -2- with the bolts -1- to 8 Nm.

-- Markings -7- on suction and return hose -8- must align with webs -5-. Secure suction and return line -8- with spring-type hose clamps -6-.

-- Secure return hose -1- with clip -2- to coolant hose -3-.

-- Secure return hose -1- with wiring bracket -4- to body bracket -5-.

-- Secure return hose -1- with clips -2- and -4- to refrigerant line -3-.

-- Attach return line -4- to line -1- and return hose -6- to line -7-.

-- Markings -5- on return line -4- and return hose -6- must align with markings -2-. Secure return line -4- and return hose -6- with hose clamps -3-.

-- Secure return line -3- with line brackets -1- to subframe -2-.

-- Secure return line -3- with bracket -5- to coolant hoses -4-.