Reducing Agent Passive Tank, Removing And Installing: Installation
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to REDUCING AGENT PASSIVE TANK AND ATTACHMENTS OVERVIEW .
-- Install the left underbody trim in the center. Refer to UNDERBODY TRIM PANELS .
-- Make sure the lines are clipped to the passive tank.
After Filling, the Following Steps Must be Performed:
-- Adapting Adaptation Value after Draining Reducing Agent or Replacing Components, refer to ADAPTING ADAPTATION VALUE AFTER DRAINING REDUCING AGENT OR REPLACING COMPONENTS .