Reducing Agent Metering System Control Module -J880- OVERVIEW
WARNING: This page is about a different variant/trim than selected.
NOTE:
Installed location: The Reducing Agent Metering System Control Module -J880- is located on the right side under the rear bench seat, directly below the floor covering.
- Bracket
- Nut
- Tightening specification: 2 Nm
- Reducing Agent Metering System Control Module -J880-
- Removing and Installing. Refer to Reducing Agent Metering System Control Module -J880-, REMOVING AND INSTALLING .
- Nut
- Tightening specification: 2 Nm