Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING: Removal

WARNING: This page is about a different variant/trim than selected.

-- Carefully pull the engine cover off the 4 bolts one after the other -arrows-.

Fig 1: Removing Engine Cover

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the -1- Exhaust Gas Temperature Sensor 2 -G448- connector.

Fig 2: Component Location On Plenum Chamber Bulkhead

Courtesy of AUDI OF AMERICA, LLC

-- Free up the electrical wire.

NOTE:

Ignore -item 2, 3 and 4-.

-- Remove Exhaust Gas Temperature Sensor 2 -G448- -item 3-.

Fig 3: Locating Primary Catalytic Converter And Sensors, Catalyst Temperature Sensor 1 -G20- (2), EGT 3 -G495- (1), EGT 2 -G448- (3) & NOx Sensor -G295- (4)

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To provide a better illustration, component location is shown from behind with engine removed.

Ignore -1, 2, 4 and 5-.