Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING: Removal

WARNING: This page is about a different variant/trim than selected.

-- Carefully pull the engine cover off the 4 bolts one after the other -arrows-.

Fig 1: Removing Engine Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and -2- and then remove the heat shield from the turbocharger.

Fig 2: Turbocharger Heat Shield And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the -1- Exhaust Gas Temperature Sensor 1 -G235- black connector and free up the wire.

Fig 3: Locating Exhaust Gas Temperature Sensor 1 -G235- Connector (1) And EGR Temperature Sensor -G98- Connector (2)

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item 2-.

-- Remove the Exhaust Gas Temperature Sensor 1 -G235- -arrow-.

Fig 4: Locating Exhaust Gas Temperature Sensor 1 -G235- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To provide a better illustration, component location is shown from behind with engine removed.