NOx Sensor 2 -G687-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove NOx Sensor 2 -G687- -1-.

Fig 1: Identifying Retainers -Arrows- And Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the mounting elements -arrows- and move the heat shield to the left.

-- Disconnect the connector -1-.

Fig 2: Identifying Nuts -Arrows-, NOx Sensor Control Module 2, And NOx Sensor 2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and remove the NOx Sensor Control Module 2 -J881- and NOx Sensor 2 -G687-.