Differential Pressure Sensor -G505-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- The Differential Pressure Sensor -G505- -3- installed on the front side.

-- Spray the hoses from the Differential Pressure Sensor -G505- with thinner before removing.

Fig 1: Component Location On Plenum Chamber Bulkhead

Courtesy of AUDI OF AMERICA, LLC

-- Pull the hoses straight off the connections to remove. The connections break off of the Differential Pressure Sensor -G505- very easily.

-- Disconnect the connector -3- from the Differential Pressure Sensor -G505-.

Fig 2: Component Location On Plenum Chamber Bulkhead

Courtesy of AUDI OF AMERICA, LLC

-- Remove both bolts and the Differential Pressure Sensor -G505-.