Install the new Turbocharger Control Module 1 -J724-

-- Install the new Turbocharger Control Module 1 -J724- in reverse order of removal.

-- Install the new screws as follows:

1. M6 x 15 with Narrow Shaft
2. M6 x 15 with Narrow Shaft
3. M6 x 15

-- Only tighten the screws by hand.

• The Turbocharger Control Module 1 -J724- must contact the retaining plate without play, but is must be possible to move it by hand.

-- Connect the Turbo E-Positioner Service Kit - Wire Set VAS6395/2 to the new Turbocharger Control Module 1 -J724-.

-- Press the v  button -item 4- to continue.

The E-Box VAS 6395 /1A displays:

1. > 1. START
2. 2. NEXT [>]

-- Select "NEXT" using the ↓  button -6-.

-- Press the v  button -item 4- to continue.

• The Turbocharger Control Module 1 -J724- moves down the adjustment range.

The E-Box VAS 6395 /1A displays:

1. X, XXX V
2. [OK]

-- Press the v  button -item 4- to continue.

The E-Box VAS 6395 /1A displays:

2. [OK]

-- Press the v  button -item 4- to continue.

The E-Box VAS 6395 /1A displays:

1. X.XXX V (Starting Up Voltage)
2. [OK]

• The Turbocharger Control Module 1 -J724- moves into the installation position.

-- Install the coupling rod.

• Installed position: Attach the thicker eye to the Turbocharger Control Module 1 -J724- shaft.

-- Install the circlips -arrows-.

• The circlips must engage audibly.

-- Gently push the Turbocharger Control Module 1 -J724- to the rear -arrow-, just until the lever -1- touches the E-Positioner Service Kit - Bracket VAS6395/5.

-- Hold the Turbocharger Control Module 1 -J724- in this position.

-- Tighten the bolts -1, 2 and 3- to 5 Nm.

-- Press the v  button -item 4- to continue.

• The Turbocharger Control Module 1 -J724- will move back and forth several times between the stops and will be set to the start up voltage.

The E-Box VAS 6395 /1A displays:

1. X.XXX V (Starting Up Voltage)
2. [OK]