Regulator Valve, Removing And Installing, 6.0L (V12): Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications, refer to REGULATOR VALVE, REMOVING AND INSTALLING, 6.0L (V12) .
NOTE:
Secure all hose connections with spring-type clamps appropriate for the model.
During installation, the cable ties must be installed at the same location.
-- Connect the hoses according to the marking making sure they are twisted.
- The location of the fuel hoses and the flow direction are marked on the regulator valve with "VL" or "RL".
-- Bleed the fuel system, refer to FUEL SYSTEM, BLEEDING .