Right Suction Jet Pump, Removing And Installing, Vehicles With 3.0L (V6)/4.2L (V8) Engines Through 05/2010: Removing

WARNING: This page is about a different variant/trim than selected.

Follow all safety precautions, refer to WORKING ON FUEL SYSTEM .

Follow the guidelines for clean working conditions, refer to CLEAN WORKING CONDITIONS .

To remove suction jet pump, fuel tank should be completely empty. Procedure to empty the fuel tank, refer to FUEL TANK, DRAINING .

-- Remove the right fuel delivery unit, refer to RIGHT FUEL DELIVERY UNIT AND Transfer Fuel Pump -G6-, REMOVING AND INSTALLING .

Fig 1: Identifying Removal Of Fuel Level Sensor Through Guide -Arrow 2- While Pressing Locking Tab -Arrow 1-

Courtesy of AUDI OF AMERICA, LLC

-- Reach into the right fuel tank opening and remove the Fuel Level Sensor -G- from the guide in direction of -arrow 2- while pressing the locking tab in direction of -arrow 1-.

-- Carefully remove the Fuel Level Sensor -G- through the opening in the fuel tank.

NOTE:

The Fuel Level Sensor -G- is shown without the fuel tank to provide a better illustration.

-- Reach through the opening on the left side of the fuel tank, press the releases and remove the delivery line -1-.

Fig 2: Fuel Delivery Unit Lines Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -2, 3 and 4-.

-- Reach through the opening in the fuel tank and pull the delivery line out through the opening on the right side of the fuel tank.

Fig 3: Removing Suction Jet Pump

Courtesy of AUDI OF AMERICA, LLC

-- Press the tab -arrow 1- and pull the suction jet pump out of the guide in direction of -arrow 2-.

NOTE:

The suction jet pump is illustrated without the fuel tank.

-- Remove suction jet pump carefully through the opening in the fuel tank.