Right Suction Jet Pump, Removing And Installing, Vehicles With 3.0L (V6)/4.2L (V8) Engines Through 05/2010: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace seals.

Verify that the suction jet pump is securely engaged.

-- Install the right suction jet pump into the guide and push on it until it clicks.

-- Push the delivery line through the opening on the right side of the fuel tank and into the left fuel tank chamber.

-- Reach through the opening on the left side of the fuel tank and install the delivery line -1- on the fuel delivery unit until it clicks.

Fig 1: Fuel Delivery Unit Lines Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -2, 3 and 4-.

-- Before installing, check the routing of the wires on the Fuel Level Sensor -G-.

Fig 2: Fuel Level Sensor Tabs Location

Courtesy of AUDI OF AMERICA, LLC

-- The wire must be clipped into the tabs -arrows- as illustrated.

-- Insert the Fuel Level Sensor -G- into the guide and press it down until it clicks into place.

-- Install the right fuel delivery unit, refer to Installing .