LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (3.0L - Fuel Supply System - Engine Code(S): CATA & CNRB) >> 20 Fuel Supply >> Fuel Pump >> Fuel Pump Control Module -J538-, REMOVING AND INSTALLING >> Removing

Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.
NOTE:

The Fuel Pump Control Module -J538- is located at the front of the fuel tank below the exhaust system and driveshaft.

-- Turn off the ignition and remove the key.

WARNING:

Danger of getting burned.

  • Allow exhaust system to cool.

-- Remove the bolts/nuts -1 and 3-.

Fig 1: Identifying Fuel Pump (FP) Control Module, Bolts -1 & 3-, And Electrical Connector -2-
GWWA20-10164Courtesy of AUDI OF AMERICA, LLC

-- Disengage the Fuel Pump Control Module -J538- at the bracket -arrows-.

-- Disconnect the connector -2-.