Accelerator Pedal Module With Throttle Position Sensors, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
Fig 1: Disconnect Throttle Position (TP) Sensor -G79- /Accelerator Pedal Position Sensor 2 -G185- 6-Pin Electrical Harness Connector -3-
-- Remove the driver side lower instrument panel cover, refer to INSTRUMENT PANEL COVERS ON DRIVER SIDE OVERVIEW .
-- Remove the driver side lower instrument panel cover mount -2- -arrow-.
-- Disconnect the connector -3-.
-- Remove screws -1 and 4- and remove accelerator pedal module.