ATF Pan, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

General Repair Instructions. Refer to REPAIR INFORMATION .

Automatic Transmission Clean Working Conditions, refer to TRANSMISSION, CLEAN WORKING CONDITIONS .

-- Remove bolts and remove rear noise insulation -2-.

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Place the used oil collection and extraction deviceV.A.G 1782 under the transmission.

Fig 2: Identifying Bolt Loosening Sequence -13 to 1-

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Wear protective eyewear.

-- Remove the drain plug -arrow A-.

-- Drain the ATF.

-- Loosen oil pan bolts in -13 to 1- sequence and remove oil pan.