Shift Mechanism Function Unit, Removing And Installing: Installing
Install in reverse order of removal. Note the following:
Tightening specifications: SHIFT MECHANISM, SERVICING, ASSEMBLY OVERVIEW
Do not bend or kink the selector lever cable.
Coat the bearings and the sliding surfaces with polycarbamide greaseG 052 142 A2.
- Selector lever in "S".
-- Slide selector lever cable into selector mechanism function unit.
-- Insert the end of the selector lever cable -2- into the shift gate joint -3-.
-- Install the clamping screw -1- through the opening at the top of the selector mechanism -arrow- using the socketT40031.
-- Secure the selector lever cable -1- with the new locking plate -2-.
- Installation position: Angled end of retaining clamp points toward rear.
-- Insert the two retaining hooks -A- in selector mechanism shift unit.
-- Position selector mechanism function unit on shift unit.
Do not bend or kink the selector lever cable.
-- Insert center console bracket by tilting function unit at the same time.
-- Install the bolts -arrows-.
-- Connect the connector -1-.
-- Install the center console bracket. Refer to Interior Equipment .
-- Install the noise insulation -2- in the shift housing.
-- Connect the connector -1- to the selector lever sensor system control module -J587- with the tiptronic switch -F189-.
-- Install front ashtray/front compartment Interior Equipment .
-- Install installation frame with Multimedia Control Head -E380- Interior Equipment .
-- Install the handle on the selector lever. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .
-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .