Selector Mechanism Shift Unit, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

-- Press boot -arrow- forward out of selector mechanism shift unit.

-- Remove the hooks -1- and -2-.

Fig 2: Identifying Hooks -1 To 2- And Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Pull selector mechanism shift unit -1- back slightly and remove screws -arrows- on center bracket -2-.

Fig 3: Identifying Bolts -Arrows-, Lower Section Of Selector Mechanism Function Unit -1-, And Centering Bracket -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove selector mechanism shift unit upward.

-- Remove center bracket upward. It may not be installed again.

NOTE:

The center bracket is only needed for factory production.