Selector Lever Handle, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "N".

NOTE:

Both the selector lever handle and the selector lever boot are removed.

-- Remove the frame for the selector lever boot -1- -arrows-.

-- Secure the locking button in its pulled-out position with a cable tie -arrow-, as illustrated.

Fig 2: Securing Interlock Button In Pulled-Out Position Using A Cable

Courtesy of AUDI OF AMERICA, LLC

-- Fold the selector lever boot -1- upward and over the selector lever handle -2-.

Fig 3: Identifying Selector Lever Boot, Selector Lever Handle And Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Open the clamp -arrow- and remove both the selector lever handle and the selector lever boot without touching the locking button.