Transmission Park Selector Switch -F305-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Part Of Shift Gate -1-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Coat the bearings and the sliding surfaces with polycarbamide greaseG 052 142 A2.

-- Guide micro-switch on longer electrical line into opening under parking lock button in selector mechanism.

-- Install the shift gate -1- from underneath.

-- Install the micro-switch -B- into the shift gate and secure it with the retaining pin -A-.

NOTE:

Micro-switch must lie flush on all sides.

-- Attach the electric wire to the tab -arrow C-.

NOTE:

Retaining screws -A- secure the micro-switch -B- inside the shift gate.

Ignition key removal lock does not function correctly if micro-switch is not inserted correctly or properly secured.

-- Secure the electric wire -arrows A- to the selector mechanism as illustrated.

Fig 2: Identifying Microswitch Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the micro-switch -B-.

NOTE:

Ignition key removal lock does not function correctly if micro-switch is not inserted correctly or properly secured.

-- Connect the connector -D- to the shift lock solenoid -N110-.

-- Install the connector -E- from the top.