Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Emergency Release Lever And Guide

Courtesy of AUDI OF AMERICA, LLC

Selector lever in "S".

-- Unclip the guide for the emergency release lever in -direction of arrow-.

-- Pull the emergency release lever -arrow- upward.

Fig 2: Identifying Manual Release Lever

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The operating lever -1- for the shift lock solenoid -N110- moves into its installed position when the emergency release lever is pulled up.

Fig 3: Placing Shift Lock Solenoid N110 Into Guide At An Angle From Above

Courtesy of AUDI OF AMERICA, LLC

-- At the same time, position the shift lock solenoid -N110- into the guide at an angle.

-- Push the shift lock solenoid -N110- into the guide until it clicks.

The ball head -2- on the shift lock solenoid -N110- must fit into the operating lever on the selector mechanism.

-- Connect the connector -1-.

Fig 4: Identifying Shift Lock Solenoid N110 Electrical Connector And Releasing Retainer And Pulling Out Shift Lock Solenoid N110 From Front

Courtesy of AUDI OF AMERICA, LLC

Perform a functionality test on the shift lock solenoid -N110-.

Fig 5: Connect Connector -1- To Selector Lever Sensor System Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -1 -.

Fig 6: Electrical Connector -1- And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Before completing the assembling, check the function of the shift lock solenoid -N110- with the selector lever in "P" and "N" SELECTOR MECHANISM FUNCTIONALITY TEST .

Further installation is done in reverse order of removal, similar to installation of selector mechanism function unit SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .