LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission 0AT - Mechanism & Housing) >> 37 Mechanism And Housing >> Shaft Seals, Replacing - Assembly Overview >> Input Shaft Seal, Replacing >> Removing

Input Shaft Seal, Replacing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove transfer case TRANSFER CASE, REMOVING AND INSTALLING .

NOTE:

For the next step, install sheet metal screw so that it jams between seal and metal ring.

Fig 1: Identifying Output Shaft Seal, Removal
GWWN34-1691Courtesy of AUDI OF AMERICA, LLC

Be careful not to install the screw too deep otherwise the bearing underneath will get damaged.

-- Install sheet metal screw in shaft seal -arrow-.

-- Remove seal with PullerT10055.

scientia non olet · About LEMON Manuals