Input Shaft Seal, Replacing: Installing
WARNING: This page is about a different variant/trim than selected.
-- Lubricate outer circumference and space between sealing lips with ATF.
- Installation position: the open side of the seal faces the transmission.
-- Carefully guide shaft seal over output shaft to transmission and lightly press in with hand.
-- Drive in shaft seal as far as stop with Thrust PieceT40134. Do not tilt shaft seal when doing so.
-- Install transfer case TRANSFER CASE, REMOVING AND INSTALLING .
-- Check the ATF level and add, if necessary. Refer to ATF LEVEL INSIDE TRANSMISSION .