Selector Lever Cable, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Before removing selector lever cable, secure a cable on selector lever cable so that it can be threaded easily when installing.

-- Press boot -arrow- forward out of selector mechanism shift unit.

-- Remove screws and remove rear noise insulation -2-.

Fig 2: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball head -2- on the selector lever cable from the selector shaft lever using the pry lever80-200.

Fig 3: Identifying Locking Washer & Selector Lever Cable

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clips -1- and then remove the selector lever cable from transmission.

NOTE:

Do not bend or kink the selector lever cable.