Selector Lever Cable, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Shift Unit & Seat Sleeve

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Secure selector lever cable to cable that was guided in during removal.

-- Guide the selector lever cable with boot -2- into the selector mechanism shift unit -1-.

CAUTION:

Selector shaft lever must not be bend when pressing selector lever cable on, counterhold if necessary.

-- Carefully remove the selector lever cable -2- from the selector shaft lever.

Fig 2: Identifying Locking Washer & Selector Lever Cable

Courtesy of AUDI OF AMERICA, LLC

-- Secure selector lever cable sleeve to bracket using a new clip -1-.

-- Carefully insert boot -arrow- all around in selector mechanism shift unit.

Fig 3: Pushing Boot Forward And Out From Shift Unit

Courtesy of AUDI OF AMERICA, LLC

-- Adjust selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING

Tightening Specification

Component		Nm
Heat shield to transmission		9