Left Coolant Pipe On Transmission, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Cover -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pull the engine cover off the four retaining pins one after the other -arrows-.

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Fig 2: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use a cloth to catch any leaking coolant.

-- Loosen the clamps -1 and 2-. Then remove both the coolant hoses and the Hose Clamps - Up To 25mm3094.

Fig 3: Identifying Left Coolant Pipe Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and then remove the coolant pipe on the left side of the transmission.