LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (3.0L - Cooling System - Engine Code: CNRB) >> 19 Cooling System >> Coolant Pipe, Coolant Shut-Off Valve, Coolant Temperature Sensor >> Engine Temperature Control Sensor -G694-, REMOVING AND INSTALLING >> Installing

Engine Temperature Control Sensor -G694-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-rings.

Insert the Engine Temperature Control Sensor -G694- immediately to prevent coolant loss.

-- Install the idler roller. Refer to OVERVIEW - RIBBED BELT DRIVE .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals