Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying MAX-Marking For Coolant

Courtesy of AUDI OF AMERICA, LLC

The engine is cold.

-- Quickly open the coolant reservoir cap and release any remaining pressure in the cooling system and then close it again.

-- Remove the engine cover -arrows-.

Fig 2: Identifying Engine Cover -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

Fig 3: Connector & Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-, and remove the Engine Coolant Temperature Sensor -G62-.