Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

CAUTION:

There is a risk of destroying the sensor wheel by magnetic force.

Do not place the sensor wheel near magnets (for example inspection lamp base, or speakers).
If the drive plate/flywheel or the sensor wheel disjoints itself or was replaced, the sensor wheel function must be checked before installing. Refer to SENSOR WHEEL, CHECKING .

Tightening specification. Refer to OVERVIEW - DRIVE PLATE .

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Be careful of the alignment bushings during installation.

-- Turn the Counterhold - Flywheel10-201 to tighten the bolts.