Crankshaft Seal, Replacing, Transmission Side

Special tools and workshop equipment required 

• Crankshaft Seal Installer KitT10122A
• Seal Installer - Crankshaft - Guide PieceT10122/6
• Puller - Crankshaft/Power Steering SealT20143/2

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

• Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using Puller - Crankshaft/Power Steering SealT20143/2.

-- Clean the running and sealing surface.

Fig 2: Guide Piece T10122/6 And Push Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Crank Shaft Seal Installer - Guide PieceT10122/1 on the Crank Shaft Seal Installer - Guide PieceT10122/6 and push the shaft seal -A- on the guide piece.

-- Remove the Crank Shaft Seal Installer - Guide PieceT10122/1.

-- Position the Crank Shaft Seal Installer - Guide PieceT10122/6 on the crankshaft.

Fig 3: Identifying Seal Installer - Crankshaft - Guide Piece T10122/6

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Guide Piece through the mounting points -A- with the bolts -arrows- on the crankshaft.

-- Push the shaft seal by hand using the Crank Shaft Seal Installer - Guide PieceT10122/6 on the crankshaft.

-- Press shaft seal in evenly all around with Crank Shaft Seal Installer - Thrust SleeveT10122/5.

Fig 4: Install Shaft Seal In Evenly All Around With Thrust Piece T10122/5 Until Flush

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Crank Shaft Seal Installer - Guide PieceT10122/6.

-- Check the shaft seal as well as the sealing lip for correct seating. If the sealing lip are partially turned repeat the procedure with a new shaft seal.

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .