LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> COOLANT PIPE AND After-Run Coolant Pump -V51- >> Front Coolant Pipe, Removing And Installing >> Installing

Front Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and O-rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Clean or smooth out the seals and O-ring sealing surfaces.

-- Coat the sealing rings and O-rings with coolant and then mount them on the coolant pipe.

-- Connect the coolant hose to the coupling. Refer to Figure.

-- Install the coolant pump ribbed belt pulley. Refer to OVERVIEW - COOLANT PUMP AND THERMOSTAT .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the left front coolant pipes. Refer to LEFT FRONT COOLANT PIPES, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals