Coolant Hoses, Assembling
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the coolant hose on the connection as follows:
- Slide the coolant hose -6- coolant hose onto the connection -1- as far as the stop -3-.
- If there is no stop, slide the coolant hose 28 mm onto the connection.
- The arrow marking -4- on the coolant hose must align with the arrow marking -2- on the connection. A line may be used as a marker instead.
- Only uses undamaged clamping sleeves -5- that match the ones used in series production.
- Position the clamping sleeves between the colored markings -7-.
- Adjust the position of the tabs on the clamp so that there is as much clearance to surrounding components as possible.