Selector Lever, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Refer to SELECTOR LEVER AND Multifunction Transmission Range Switch -F125- .
Refer toFig 2.

Fig 1: Identifying Selector Lever Cable Ball Head -1- And Cable Mounting Bracket Bolt -2-

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger of causing damage to the transmission selector lever.

Do not bend the transmission selector lever when installing the selector lever cable. Control it if necessary.

-- Press the selector lever cable -1- carefully onto the selector lever.

NOTE:

Ignore item -2-.

Install in reverse order of removal. Note the following:

-- Install the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Fig 2: Identifying Selector Lever Cable Heat Shield - Tightening Specification

Courtesy of AUDI OF AMERICA, LLC