LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Oil Pan, Oil Screen, Valve Body Selector Lever & MULTIFUNCTION Transmission Range Switch -F125-) >> 38 Gears, Hydraulic Controls >> Oil Pan, Oil Screen And Valve Body >> Valve Body, Removing And Installing >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Component Nm
Transmission Fluid Temperature Sensor -G93- 10
Fig 1: Identifying Valve Body Bolts
GWWN38-10040Courtesy of AUDI OF AMERICA, LLC
NOTE:

Replace bolts that are tightened to the specification.

-- Tighten the bolts in 3 steps as follows:

Step Bolts Tightening Specification/Additional Turn
1. -Arrows- Tighten the bolt hand-tight.
2. -Arrows- 8 Nm diagonally
3. -Arrows- 90° additional turn, diagonally
scientia non olet · About LEMON Manuals