Right Cylinder Head Cover, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the ignition coils. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
-- Remove the cover -arrow-.
-- Disconnect the connector -1-.
CAUTION:
Danger of defects caused by dirt.
- Follow the guidelines for cleanliness when working on the fuel supply system. Refer to FUEL SUPPLY, INJECTION SYSTEM AND CHARGING SYSTEM, CLEAN WORKING CONDITIONS .
WARNING:
Risk of injury from fuel.
- To reduce fuel pressure, lay cloths around connecting point before opening fuel system and carefully loosen.
-- Remove the bolts -arrows-.
-- Loosen the union nut -2- and swivel the fuel supply line to the side.
-- Seal the open lines and connections with clean plugs from the Engine Bung SetVAS6122.
CAUTION:
Risk of violating emissions legislation.
- Do not open the hose connection -arrow-.
-- Remove the bolts in the following sequence -12 through 1- and lay the right cylinder head aside with the crankcase ventilation hose -arrow- connected.