LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 15 Cylinder Head, VALVETRAIN >> Chain Drive >> Power Take-Off Drive Chain, Removing And Installing >> Removing

Power Take-Off Drive Chain, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

CAUTION:

Danger of damaging the drive chain because the bolt thread is too long.

  • Use bolts with a 22 mm maximum thread length -a- to attach the Crankshaft KeyT40049.
  • If only longer bolts are available, then the bolt head must be installed in such a way so that thread length is still 22 mm only.
Fig 1: Identifying Crankshaft Key T40049
GWWA13-10747Courtesy of AUDI OF AMERICA, LLC

-- Install the Crankshaft KeyT40049 with 2 bolts -arrows- on the back of the crankshaft.

Fig 2: Identifying Key T40049 At Rear On Crankshaft
GWWA13-10478Courtesy of AUDI OF AMERICA, LLC

-- Remove the locking bolt -arrow- for the Top Dead Center (TDC) marking crankshaft from the cylinder block.

Fig 3: Identifying Crankshaft Locking Bolt
GWWA15-10525Courtesy of AUDI OF AMERICA, LLC

-- Rotate the crankshaft in the direction of engine rotation to "TDC".

-- Install the Crankshaft Locking PinT40069 in the hole and tighten to 20 Nm. Rotate the crankshaft -1- back and forth slightly to center the pin completely, if necessary.

Fig 4: Crankshaft Locking Pin T40069
GWWA13-10125Courtesy of AUDI OF AMERICA, LLC

-- Press the chain tensioner guide rail in direction of -arrow- and secure chain tensioner using a Locking PinT40071.

CAUTION:

Risk of destroying due to reversed running direction on a used drive chain.

  • Mark the drive chain running direction with arrows using paint for installation later. Do not mark the drive chain with a punch, notch or something similar.

-- Remove the bolts -3- and the balance shaft chain sprocket.

-- Remove the bolts -1 and 2- and the chain tensioner with the chain.

Fig 5: Pressing & Securing Chain Tensioner Using Locking Pin T40071
GWWA13-10479Courtesy of AUDI OF AMERICA, LLC