Transmission Park Selector Switch -F305-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Part Of Shift Gate -1-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Coat the bearings and the sliding surfaces with Polycarbamide GreaseG 052 142 A2.

-- Guide micro-switch on longer electrical line into opening under parking lock button in selector mechanism.

-- Guide the shift gate -1- from underneath.

Shift gate selector lever in "S" (as illustrated).

-- Install the micro-switch -B- into the shift gate and secure it with the retaining pin -A-.

The micro-switch must be flush on all sides.

-- Engage the wiring into the tab -arrow C-.

NOTE:

Retaining screws -A- secure the micro-switch -B- inside the shift gate.

The ignition key removal lock will not function correctly if the micro-switch is not inserted correctly or properly secured.

-- Secure the electric wire -arrows A- to the selector mechanism as illustrated.

Fig 2: Identifying Microswitch Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the micro-switch -B-.

NOTE:

The ignition key removal lock will not function correctly if the micro-switch is not inserted correctly or properly secured.

Install in reverse order of removal. Note the following:

-- Install the shift gate. Refer to SHIFT GATE, REMOVING AND INSTALLING .

-- Install shift mechanism function unit. Refer to SHIFT MECHANISM FUNCTION UNIT, REMOVING AND INSTALLING .