Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "N".

-- Unclip the frame for the selector lever boot -1- and remove it from the center console -arrows-.

-- Fold up the selector lever boot.

-- Release the retaining spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -1- in direction of -arrow-.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.