Overview - Selector Lever Handle

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Knob, Boot And Transmission Range Position Display Unit Overview

Courtesy of AUDI OF AMERICA, LLC

Clamp
- For securing the selector lever handle to the selector lever.
- Removing and installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
Trim Ring
- Removing and installing. Refer to SELECTOR LEVER BOOT, REMOVING FROM SELECTOR LEVER HANDLE .
Selector Lever Handle
- Removing and installing. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
Selector Lever Boot
- Removing. Refer to SELECTOR LEVER BOOT, REMOVING FROM SELECTOR LEVER HANDLE
Selector Lever Transmission Range Position Display Unit -Y26-
- Must not be removed to remove selector lever handle.
- Removing and installing. Refer to Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING .