Balance Shaft Roller Bearing, Replacing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

-1- Puller - Kukko Internal - 20-30mm21/4
-4- Puller - Kukko Counterstay 22/2
Seal Installer - Selector Shaft Oil SealT10174

Procedure

Fig 1: Identifying Puller - Kukko Internal - 20-30 mm 21/4 and Puller - Kukko Counterstay 22/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .

-- Remove the ball bearing with Puller - Kukko Internal - 20-30mm21/4 and Puller - Kukko Counterstay 22/2.

-- Attach a roller bearing and install it carefully with the Seal Installer - Selector Shaft Oil SealT10174 until it is flush in the cylinder head.

Fig 2: Identifying Seal Installer - Selector Shaft Oil Seal T10174

Courtesy of AUDI OF AMERICA, LLC

-- Install the balance shaft. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .