Rear Output Flange And Driveshaft Seal, Transfer Case Installing, Removing And Installing: Notes
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Unit InjectorT10055
- Puller - Unit Injector - Adapter 2T10055/2
- Seal Installer - Inner Output ShaftT10399
- Seal Installer - Flange ShaftT10450
- Sealing GreaseG 052 128 A1
- Screw, approximately 4 mm diameter
- Pry lever approximately 600 mm (for example, Hazet 652-24)