Input Shaft Seal, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the transfer case. Refer to TRANSFER CASE .
-- Make a hole in the center of the shaft seal with a drift.
-- Install the 4 mm diameter screws.
NOTE:
Do not damage sealing surface on the input shaft when doing so.
Be careful not to install the screw too deep otherwise the bearing underneath will get damaged.
-- Remove the seal with Puller - Unit InjectorT10055.