Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connectors -3- and free them up.

-- Press the release buttons and remove the secondary air hoses -1-.

NOTE:

Ignore items -2 and 5-.

-- Remove the nuts -4- and the Secondary Air Injection Pump Motor -V101-.

Fig 2: Component Location Of AIR Pump Motor -V101-

Courtesy of AUDI OF AMERICA, LLC