LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Final Drive & Differential - Transfer Case 0BU, Front Final Drive 0BM, 0C1, 0BN & Rear Final Drive 0BP) >> 39 Final Drive, Differential >> Rear Final Drive Bonded Rubber Bushing, Replacing >> Rear Bonded Rubber Bushing, Removing And Installing >> Installing

Rear Bonded Rubber Bushing, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Horizontal Alignment Of Small Hole And Large Recesses
GWWN39-10553Courtesy of AUDI OF AMERICA, LLC

-- Mount the bonded rubber bushing on the final drive in its installed position.

NOTE:

The small hole and the large recesses on the bonded rubber bushing -arrows- must be horizontal to the final drive. The small hose faces outward.

-- Install the bonded rubber bushing.

Fig 2: VAS 6178 Location
GWWA39-10655Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals